Static Screen Protector Apply Guide

Wipe the screen.


Use the attached 3M scotch tape to stick out dust and hair (dust and hair will cause bubbles!)


See whether side 1 can be peeled off.

See whether side 2 can be peeled off.

Peel off ~2 inches of side 1.

Start apply, align to the corners.

Use your fingers to press a bit on the top and bottom of screen protector and roll to the other end.
If found any bubbles just pull back and re-apply.

If found any hair or dust just pull back and use attached 3M scotch tape to stick it out.

After the screen protector is fully attached to the screen, pull out side 2.

Done :)

Laptop Skin Application Guide ~ it's easy!

Wipe the laptop and make sure no dust on it.

Peel off 1~2 inches of the protective film, start apply from the upper side of the exterior.

Align the film to the upper of the laptop.

Rotate the laptop, use the cloth (thumb also can) wipe it back and forth.

If any bubble appeared, pull back the film and re-apply.
If any hair or dust found during apply, use the scotch tape to stick it out.

Done.

Film around keyboard area.

Same method apply the wristpad film, use the track pad to align.

Film for track pad.

Same method applying the base film.

Done!

When apply the hinge, press on the film, and use hair dryer to blow until it stick on it.
Same to other part of film which you think doesn't stick firmly.

Looks great after apply the skin.

Looks good isn't it :)

** Matted surface/Sloping Edges Application Instruction

(Pls click to enlarge)

*The guide is applicable to every model. Hair dryer only needed for sloping edges.